In the Linux kernel, the following vulnerability has been resolved:
can: sun4ican: populate ndochange_mtu() to prevent buffer overflow
Sending an PFPACKET allows to bypass the CAN framework logic and to directly reach the xmit() function of a CAN driver. The only check which is performed by the PFPACKET framework is to make sure that skb->len fits the interface's MTU.
Unfortunately, because the sun4ican driver does not populate its netdeviceops->ndochange_mtu(), it is possible for an attacker to configure an invalid MTU by doing, for example:
$ ip link set can0 mtu 9999
After doing so, the attacker could open a PFPACKET socket using the ETHP_CANXL protocol:
socket(PF_PACKET, SOCK_RAW, htons(ETH_P_CANXL))
to inject a malicious CAN XL frames. For example:
struct canxl_frame frame = {
.flags = 0xff,
.len = 2048,
};
The CAN drivers' xmit() function are calling candevdroppedskb() to check that the skb is valid, unfortunately under above conditions, the malicious packet is able to go through candevdroppedskb() checks:
the skb->protocol is set to ETHPCANXL which is valid (the function does not check the actual device capabilities).
the length is a valid CAN XL length.
And so, sun4icanstartxmit() receives a CAN XL frame which it is not able to correctly handle and will thus misinterpret it as a CAN frame.
This can result in a buffer overflow. The driver will consume cf->len as-is with no further checks on this line:
dlc = cf->len;
Here, cf->len corresponds to the flags field of the CAN XL frame. In our previous example, we set canxl_frame->flags to 0xff. Because the maximum expected length is 8, a buffer overflow of 247 bytes occurs a couple line below when doing:
for (i = 0; i < dlc; i++)
writel(cf->data[i], priv->base + (dreg + i * 4));
Populate netdeviceops->ndochangemtu() to ensure that the interface's MTU can not be set to anything bigger than CAN_MTU. By fixing the root cause, this prevents the buffer overflow.